1.Set the length of copper wire: The actual copper wire length required varies with different product specifications. A value of 100 corresponds to approximately 5MM of wire length, which should be set according to the exact wire length requirements of your product on the cnc transformer winding machine.
2.The last loop pulling angle: This parameter is used to adjust the position of the tail wire after the product is wound on the cnc transformer winding machine. A value of 0 means no tail wire position adjustment- the product will be output at the exact position where the last loop is pulled down by the crochet hook. A non-zero set value adjusts the tail wire position; the larger the value, the higher the final tail wire position will be lifted.
3.The first circle of multi-turn angle: This angle parameter on the cnc transformer winding machine sets the wire distance gap between the first and second loops. A larger value results in a wider gap, which is associated with the number of cutting coils.
4.Vertical hook drop speed: The default winding speed of the cnc transformer winding machine is set to 50 at the factory. Note that a larger numerical value indicates a slower speed, while a smaller value indicates a faster speed. The recommended setting for most applications is 50.
5.Set the number of winding: The set value represents the actual number of winding cycles on the cnc transformer winding machine. For example, a setting of 10 will result in exactly 10 winding cycles.
6.Start cutting coil number: This parameter specifies which loop to trigger wire cutting on the cnc transformer winding machine. The set value must be less than or equal to the number of winding cycles; a value exceeding the winding cycles will disable the wire cutting function.
7.The first circle of cable angle: This angle on the cnc transformer winding machine sets the position where the first loop of wire is wound onto the magnetic ring clamp, primarily to prevent hook skipping on the first loop.
8.The first circle hook line length: This value determines the staying position of the vertical hook for the first loop during operation on the cnc transformer winding machine.
9.The number of suspended work: This parameter on the cnc transformer winding machine facilitates separate packaging counting. For instance, a setting of 500 will trigger an alarm after 500 finished products are processed. Setting it to 0 disables this function.
10.Allow the baffle to extend: A setting of 1 activates the baffle function on the cnc transformer winding machine, while a setting of 0 deactivates it.
11.Detect the number of copper wires: A setting of 2 enables full wire detection on the cnc transformer winding machine; 0 turns off the detection function; 1 enables detection for only a single wire strand.
12.Length of copper wire per circle: This parameter is used to set the wire length per individual loop on the cnc transformer winding machine.
13.The front hook line speed: This parameter on the cnc transformer winding machine sets the speed at which the vertical hook weight travels from the top position to the first sensor after the magnetic ring is loaded.
14.Slow 1 Fast 2: This speed mode parameter on the cnc transformer winding machine- set to 1 for slow mode, 2 for fast mode. Wires with a diameter below 0.4mm are suitable for fast mode, while wires with a diameter above 0.4mm should use slow mode.
